| Resource: Concrete Cutter/Multi-Processor for Hydraulic Excavator | ||||||||
|---|---|---|---|---|---|---|---|---|
|
Category: Public Works and Engineering
Kind: Equipment |
||||||||
| Minimum Capabilities (Component) | Minimum Capabilities (Metric) |
Type I MP40 CC (Largest) |
Type II MP30 CC |
Type III MP20 CC |
Type IV MP15 CC (Smallest) |
Other | ||
| Jaw Opening | Inches | 50.4 | 38.4 | 32 | 26 | |||
| Jaw Depth | Inches | 43.3 | 35 | 31 | 26 | |||
| Force at Tooth Tip | Short Ton | 168 | 140 | 107 | 79 | |||
| Force Primary Blade Center | Short Ton | 494 | 460 | 337 | 247 | |||
| Weight of Jaw | Pounds | 4,850 | 7,935 | 5,730 | 3,970 | |||
| Weight With housing | Pounds | 12,785 | 20.5 | 18 | 16 | |||
| Cutter Length | Inches | 23.6 | 110.2 | 95 | 87 | |||
| Length | Inches | 137.8 | 208 | 157 | 112 | |||
| Force At Cutting Tip | Short Ton | 247 | 2,865 | 2,205 | 1,430 | |||
| Max Op Pres Hyd. Cylinder | Pressure Per Square Inch | 5,075 | 5,075 | 5,075 | 5,075 | |||
| Maximum Oil flow Cylinder | Gallons Per Minute | 106 | 79 | 53 | 40 | |||
| Maximum Oil flow Cylinder | Cycle-Seconds | 7.5 | 6.5 | 6 | 5 | |||
| Maximum Operating Pressure Rotator | Pressure Per Square Inch | 2,030 | 2,030 | 2,030 | 2,030 | |||
| Maximum Oil Flow Rotator | Gallons per minute | 22 | 11 | 11 | 11 | |||
| For Use on Models | 375, 375 L Hydraulic Excavators | 345B L Series II Hydraulic Excavators | 322C L, 325C L Hydraulic Excavators | 321 B LCR, 322C L Hydraulic Excavators | ||||
|
Comments: Multiprocessors do the work of any types of demolition tools by use of interchangeable jaw sets. Changing jaws allows a single unit to crush, pulverize, and perform a variety of specialized cutting tasks, such as cutting steel rebar and tanks. Check with Cat dealer/owner to match Multiprocessor model attachment to Hydraulic Excavator. rx-med.net |
|
|
|
| National Mutual Aid & Resource Management Initiative |
Public Works
|